Digicom 8D5684QB Guía de usuario descargar pdf (Pagina 25)

3.11

Pocket AL I/O QB Conﬁguration

Example of alarm messages of contact 15

HOME

15)MainPower ON

BATTERY: CHARGING

HOME

15)MainPower OFF

BATTERY: LOW

3.8. STANDBY MANAGEMENT

Pocket AL I/O QB is always active but it may be necessary to interrupt its operation temporarily and put it in STANDBY status

without powering it off.

For particular needs you can also leave Pocket AL I/O QB always in Standby status. In this way, as you will not be automatically

informed, you can verify the inputs status by remote querying Pocket AL I/O QB with the #TEST# message described in the next

paragraph.

Pocket AL I/O QB can be remote enabled or disabled through a proper conﬁguration message.

In STANDBY status Pocket AL I/O QB will not send automatically any message so no Status/Transition change will be signalled

as well as the main power off.

Just after the remote activation, Pocket AL I/O QB will send a conﬁrmation message to the user that requested the status change

specifying the current device status.

3.8.1. Standby conﬁguration message

The message format to set the STANDBY function is the following:

# STANDBY # User 1 # User 2 # User 3 # User 4 # User 5 # User 6 #

NAME VALUE DESCRIPTION

STANDBY STANDBY Key used for the standby conﬁguration: STANDBY

User n + 0..9 Phone numbers of the users enabled to manage the standby (up to six phone numbers can

be inserted)

NOTES

1. If you want to add a phone number to the already set list, it will be necessary to insert all the numbers

again.

2. The users' phone number can include or not the international preﬁx precedeed by + character (i.e.

+393351122334).

3. 0 (zero) character inserted in User 1 will cancel the whole list.

4. If User ﬁeld is empty, anyone will be able to manage the standby

Examples

#STANDBY#+393359988776#

#STANDBY#0#

3.8.2. Standby enabled/disabled message

The enabling/disabling of Pocket AL I/O QB can be controlled only by authorized users whose phone numbers are inserted during

the STANDBY status conﬁguration.

#ENABLE# It enables Pocket AL I/O QB operative status (STANDBY disabled)

#DISABLE# It disables Pocket AL I/O QB (STANDBY enabled)

NOTE

1. The words ENABLE and DISABLE are accepted both in upper and lower case.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

Comentarios a estos manuales

Sin comentarios

Digicom 8D5684QB Guía de usuario Pagina 25

Comentarios a estos manuales