Digicom 8D5684QB Guía de usuario descargar pdf (Pagina 9)

2.1

Pocket AL I/O QB QB Installation

2. INSTALLATION

The installation of Pocket AL I/O QB QB is extremely easy and fast. The conﬁguration can be performed locally through a terminal

emulator or remotely through a common GSM phone and SMS messages.

2.1. HARDWARE INSTALLATION

Before going on with the conﬁguration, it is necessary to complete the hardware installation of Pocket AL I/O QB QB. Connect the

sensors to the input contacts of Pocket AL I/O QB QB and then connect the eventual devices to be remote piloted to the output

pins. When Pocket AL I/O QB receives the conﬁguration messages, it will store the current situation of that input as “non alarmed”

status, whether it is OPEN or CLOSED.

2.1.1. Starting procedure

• Connect Pocket AL I/O QB to a computer COM port. The device in factory conﬁguration accepts commands at 115200 bps

only. This operation is not necessary in case you conﬁgure the device via SMS.

• Connect the inputs and outputs to be managed. See the next paragraphs for the pins of terminal boards.

• Connect the GSM antenna.

• Insert the SIM card into Pocket AL I/O QB.

• Power on Pocket AL I/O QB. See the next paragraph for the 6 PINs terminal board.

2.1.2. 6 PIN terminal board description

Front view PIN LABEL DESCRIPTION

PWR 1 + Power from +5 to +32 Vcc

2 - GND ground

4-20mA 3 + Power per sensor Out +12Vcc

4 S Analog input 1

5 + Power per sensor Out +12Vcc

6 S Analog input 2

2.1.3. 20 PIN terminal board description

Front view PIN DESCRIPTION

IN 1 GND ground

2 Non optoinsulated input 1

3 Non optoinsulated input 2

4 Non optoinsulated input 3

5 Non optoinsulated input 4

6 GND ground

O.C. 7 Open Collector output 1

8 Open Collector output 2

9 Open Collector output 3

10 Open Collector output 4

OPT 11 Optoinsulated input 1

12 Optoinsulated input 1

13 Optoinsulated input 2

14 Optoinsulated input 2

RL1 15 Relay output 1 N.A.

16 Relay output 1 C

17 Relay output 1 N.C.

The wires must be stripped for about 10 mm RL2 18 Relay output 2 N.A.

so you can insert them correctly in the female clips 19 Relay output 2 C

20 Relay output N.C.

NOTE:

Open Collector: max 60Vcc - 700mA Optoinsulated input: from 5Vcc to 32Vcc

Relay output: max 60Vcc - 1A

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Comentarios a estos manuales

Sin comentarios

Digicom 8D5684QB Guía de usuario Pagina 9

Comentarios a estos manuales