Digicom 8D5684QB Guía de usuario descargar pdf (Pagina 31)

5.1

Pocket AL I/O QB Pocket AL I/O QB Applications

5. Pocket AL I/o QB APPLIcAtIoNS

Pocket AL I/O QB comes from Digicom know-how of PocketGSM AL and ArchimedeSMS; this allowed to identify the speciﬁc

applications of the new product. The applications “M2M” and “GATE” have been implemented to increase the performances of

Pocket AL I/O QB identiﬁed by “AL” application.

To enable one of the three applications you must send these comands:

#AL# It enables the general application

Factory default

#M2M# It enables the M2M application

#GATE,output key# It enables the GATE application

Through the #CONFIG# command you can verify which application is active on Pocket AL I/O QB.

Attention: passing from an application to another will cause the device reset to factory conﬁguration.

5.1. M2M APPLICATION

In this application a couple of Pocket AL I/O QB interacts without the presence of a user. After an input status change of the ﬁrst

device a notiﬁcation is sent directly to the second Pocket that will open or close the output.

The input of a Pocket will interact directly with the output of the second Pocket. It is really important that input and output are set

with the same ID.

The M2M application brings only a sempliﬁcation of signalling messages in order Pocket can interprete the message and manage

the output.

ATTENTION: This kind of management requires a careful analysis of the application to avoid dangerous

malfunctions that may compromise the whole installation.

5.1.1. Alarm messages

After the detection of input status/transition change, Pocket AL I/O QB will send the following messages:

Device ID#input ID ON

Device ID#input ID OFF

5.1.2. Outputs management

Pocket AL I/O QB will modify the output status when it receives an SMS message as described in the previous paragraph.

After the output status change, a conﬁrmation SMS is sent.

NOTE: It is very important that the phone number sending the SMS is set in the "User" authorized to modify

the output.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

Sin comentarios

Digicom 8D5684QB Guía de usuario Pagina 31