
1.1
Pocket AL I/O QB Introduction
1. INTRODUCTION
Congratulations for choosing Pocket AL I/O QB Digicom.
Pocket AL I/O QB is a signalling system via SMS equipped with a last
generation Quad-Band GSM/GPRS modem.
It can interface to different sensors according to your needs (i.e. gas,
allarms, fumes, water or level sensors, etc.) and then it sends you an SMS
at any change detected on each single sensor.
Furthermore you will be able to remote interact by sending appropriate
SMS that will pilot the opening/closing of the outputs.
Pocket AL I/O QB has been designed to operate with the networks of all
the GSM operators both directly and in roaming mode.
Pocket AL I/O QB complies with Class 4 (850/900 MHz) and Class 1
(1800/1900 MHz).
1.1. Technical feaTures
• Powersupply
Power supply: from 5 to 32 Vcc
• Temperature
Operating: from -20°C to +55°C
Storage: from -20°C to +70°C
• Connectors
Terminal board 6 PIN screwless
Power
Two analog inputs
Terminal board 20 PIN screwless
Four non optoinsulated digital inputs
Two optoinsulated digital inputs
Four open collector outputs
Two relay outputs (NO, C, NC)
Antenna SMA female
SIM Plug-In 3V and 1,8V (USIM are not supported)
Data RS232 9 pin (V.24/V.28)
It allows to connect the device to the PC in order to set it up via serial port (it can be also setup via SMS
messages) and for firmware upgrades.
• Overalldimensions
Size 90x77x47mm
Weight about 300 gr
1.2. Package conTenT
• 1PocketALI/OQB
• 1GSMAntenna
• 1User'sGuide
Comentarios a estos manuales